Advertisement
USING MORE THAN ONE MICROPHONE
It is often desirable for a group to use a separate micro-
phone for each individual performer. In this case, the
following points should be remembered:
1.
It is best if the microphones are individually controlled
for volume through a separate Shure microphone
mixer. If this is not possible, it is desirable that each
performer use the sarne type and rnodel
of
microphone
so that the group as a whole wjil1 he "halanced."
2. Check the placement of the microphones with relation
to loudspeakers (as previously mentioned) so that
feedback is minimized.
3. As additional microphones are added the possibility of
feedback increases. Turn off, or down, unused micro-
phones to help solve this problem.
SHURE FEEDBACK CONTROLLER
Lets you "tune" your sound system to the acoustics of the
room. The result is more overall sound power without
feedback. Eight linear-motion filter controls are infinitely
variable from
0
to 12 dB cut. Below 63 Hz and Above
8 kHz roll-off switches attenuate low and high frequencies.
Can be installed between mixer or console and amplifier
for total system control, or following each microphone as
a single-channel preamplifier with feedback control.
Advertisement
