Graco 16Y385 TrueCoat 360 Owner's Manual page 9

5. Tilt the sprayer so the VacuValve is the
highest point, causing any air in the
FlexLiner to rise to the VacuValve.
Gently squeeze the FlexLiner to
evacuate all air through the VacuValve
air hole. Once you see material enter the
VacuValve reservoir, all air should be
evacuated from the FlexLiner.
ti23345a
6. Stop squeezing the FlexLiner and snap
the VacuValve cap closed. You will hear
the cap click when it is closed properly.
ti23355a
7. Plug sprayer into power source.
8. Turn Prime Pump/Spray knob down to
Prime Pump position. To fill sprayer with
fluid, point sprayer into a waste area and
hold the trigger in for 5–10 seconds.
ti23285a
333394H
Prime Pump
ti23354a
9. Turn Prime Pump/Spray knob forward to
spray position.
10. Make certain spray tip is in the spray
position.
SPRAY
11. You are now ready to spray.
NOTE: For best results; to evacuate all
material from the FlexLiner when the material
is nearly gone, gently squeeze the bottom of
the FlexLiner to push the last of the material
up to the cup lid.
Start Up
Spray
ti23288a
UNCLOG
ti23290a
9