Graco 16Y385 TrueCoat 360 Owner's Manual page 15

3. Set the sprayer upside down on a flat
surface. This will keep the wet paint in
the cup cover. Return excess material to
original container. Hold the FlexLiner in
place when pouring.
4. You can either dispose of the used
FlexLiner and install a new FlexLiner or
clean a used FlexLiner.
5. To clean the sprayer, fill FlexLiner
approximately half-full with appropriate
cleaning fluid (water or mineral spirits).
6. Securely tighten cup cover onto cup
support.
7. To clean the cup cover and strainer,
secure the cup assembly to the sprayer
and shake the entire sprayer for ten
seconds.
333394H
8. Make certain the Prime Pump/Spray
knob is in the Prime Pump position
(pointed down). On models with a dual
speed control switch, set speed control
to HIGH. On variable speed models set
speed control to 10.
9. Turn the sprayer upside down and point
the sprayer into a waste pail. Pull the
ti23387a
trigger for ten seconds.
10. Turn Prime Pump/Spray knob forward to
SPRAY position. Reverse spray tip to
UNCLOG position.
11. While holding the sprayer upside down
point the sprayer into a waste pail. Pull
the trigger for five seconds. Release the
trigger.
ti23383a
12. If second spray tip was used, remove
cleaned spray tip from spray tip guard
and install second spray tip. See
Installing Spray Tips, page 18. Repeat
steps 10 and 11 to clean second spray
tip.
Cleanup
ti23384a
ti23388a
15