Table of Contents
Advertisement
Prisma EtherLinX Unit Installation Instructions
Introduction
The Prisma EtherLinX unit comes ready to install; there is no hardware
configuration required. All features, such as FiberAlert and Auto-Negotiation, are
software configurable. Refer to the Help file for configuration information.
Follow these steps to install the Prisma EtherLinX unit.
1.
Place the unit on a suitable flat surface.
2.
Attach the cables between the Prisma EtherLinX unit and each device that is
to be interconnected.
3.
Plug the unit into a reliable, filtered power source.
Wall-Mount Installation
Follow these steps to wall mount the Prisma EtherLinX unit.
1.
Attach the wall-mount bracket to the Prisma EtherLinX unit using the
supplied screws.
2.
Mount the unit to the wall by tightening the screws (not supplied).
3.
Attach the cables between the Prisma EtherLinX unit and each device that is
to be interconnected.
4.
Plug the unit into a reliable, filtered power source.
4008226 Rev B
Screw holes for
mounting unit to
wall. Wall-mount
bracket must be
attached to the
Screw holes for mounting
wall-mount bracket to unit
with supplied screws.
unit.
T11389
Continued on next page
17
Advertisement
Table of Contents
