ZyXEL Communications MAX218M Support Note page 14

Hide thumbs Also See for MAX218M:
Table of Contents

Advertisement

524
"Initial ranging T21 timeout: No valid DCD to decode DL-MAP within
T21"
525
"T2 timeout: No ranging opportunity in UL-MAP within T2"
526
"Weak signal, ranging code retries exhausted"
527
"RNG-REQ retries exhausted (No RNG-RSP from BS, check MAC addr)
or RNG-REQ CANNOT be sent"
528
"MAP FEC is NOT supported"
529
"Weak signal, PHY error reported"
530
"RNG-REQ retries exhausted due to no CDMA_Alloc_IE"
531
"No preferred Channel in CDB."
532
"Ranging Error"
600
"Authorization failed"
601
"Auth Fails: BS does not activate EAP. (Suggestion: Check MAC
Address or SBC TLVs)"
602
"Auth Fails: BS does not send SA-TEK-Challenge. (Suggestion: EAP
Outer ID format is accepted, but collided)"
603
"Auth Fails: BS sends SA-TEK-Challenge with invalid AKID."
604
"Auth Fails: BS does not send SA-TEK-Response."
605
"Auth Fails: EAP is not negotiated in SBC."
606
"Auth Fails: EAP Fails (Suggestion: 1.Check Auth Configuration.
2. EAP Outer ID format is not accepted)."
607
"Auth Fails: Auth Request at unexpected state."
608
"Network Entry Timeout: Wait for Auth."
700
"Host Disconnect during NwEntry"
800
"Weak signal, no target BS to handover"
801
"Cannot return SBS, resource retain timer expired"
802
"the return to serving BS failed"
900
"UMAC assert"
901
"PHY error"
902
"PHY is reset during initial RNG/search NET/assocn"
903
"PHY is reset during HO RNG/Fast RNG/return SBS/idle HO"
904
"PHY is reset during location updt/idle reentry"
905
"PHY is reset during PRNG/unsolicited PRNG/keep alive/PHY
initiated PRNG"
906
"BS doesn't allocate BW for a long time after BR is sent"
907
"Idle Mode Timer timeout"
908
"PS request to change BS and starts NWentry"
909
"Keep alive check failed"

Advertisement

Table of Contents
loading

Table of Contents