Connections - Panasonic TH-50LFB70W Operating Instructions Manual

Connections

AC cord connection and ¿ xing, cable ¿ xing
When using the Wall-hanging bracket (vertical) (for 50 inch model)
Note:
When using the Wall-hanging bracket (vertical)(TY-WK42PV20), use the holes
clamper is used on the hole
50 inch model
Using the clamper
Secure any excess cables with clamper as required.
Note:
One clamper is supplied with this unit. In case of securing cables at three positions, please purchase it separately.
If you need more clampers, purchase them from your dealer. (Available from the customer service)
Attach the clamper
1
hole
Insert the clamper
in a hole.
How to use the Ferrite core
PC with DVI-D
video out
Less than
5 cm
10
AC cord ¿ xing
Plug the AC cord into the display unit.
Plug the AC cord until it clicks.
Note:
Make sure that the AC cord is locked on
both the left and right sides.
, the cables may be caught by the wall-hanging bracket.
65 inch model
To remove from the unit:
snaps
Keep pushing
both side
snaps
Shared with PC IN.
Stereo mini plug (M3)
Less than
Ferrite core
5 cm
(supplied)
DVI-video cable (Within 5 m)
Bundle the cables
2
Set the
tip in the
hooks
hooks
Unplug the AC cord
Unplug the AC cord pressing the
two knobs.
Note:
When disconnecting the AC cord, be
absolutely sure to disconnect the AC
cord plug at the socket outlet ¿ rst.
and to secure the cables. If the
To loosen:
Keep
pushing
knob
the knob
Installing the Ferrite core
1 . 2.
Pull back the tabs Open the
(in two places) Ferrite core
3. 4.
Route the cable
Fix the Ferrite core
through and close
with the cable tie