Safety Label Locations; Setting Up Your New Mower - Honda HRC216PDA Owner's Manual

SAFETY LABEL LOCATIONS

These labels warn you of potential hazards that can cause serious
injury. Read them carefully. If a label comes off or becomes hard to
read, contact an authorized Honda servicing dealer for a replacement.
DO NOT OPERATE UNLESS GUARD
IS CLOSED OR BAG IS IN PLACE
KEEP HANDS and FEET AWAY
HOT MUFFLER CAN BURN YOU.
Stay away if engine has been running.
SETTING UP YOUR
NEW MOWER
Loose Parts
Use the following included loose parts to set up the lawn mower.
Part
Handle support plate
Handle support hanger
Flange bolt (8 x 16 mm)
Flange bolt (8 x 40 mm)
Self-locking nut (8 mm)
Handlebar Setup
1. Pry open the right side handle support hanger, and place it over
the right handle above the starter rope guide. Squeeze the ends
together. Make sure the ribs are facing out, as shown.
STARTER ROPE
GUIDE
2. Slip the left handle support hanger over the end of the handlebar
and slide past both bolt holes. Make sure the ribs are facing out.
3. Position the handlebar onto the handle stay, and loosely install the
two 8 x 16 mm flange bolts through the handlebar lower bolt holes.
HANDLE STAY
8 x 16 mm
FLANGE BOLT (2)
Quantity
2
2
2
2
6
RIBS
OUT
RIBS OUT
3