Aiwa NSX-MT960 Service Manual page 44

SPEAKER DISASSEMBLY INSTRUCTIONS
Type.1
HPo)4MEizY-fj-x F
TqIT–%%L&hT.lY$)b%%
LiFzl_o 4w(Dx E-YJ-z=Y F(DI?x EIEK). xF–
3J-QGY b& fiLT<ti21/I.
Insert a flat-bladed screwdriver into the position indicated by the
arrows and remove the panel, remove the screws of each speaker
unit and then remove the speaker units.
Type.2
yIj)~Y~–AgfiL,4 ~~~&+~ygT~*x~yq
)Y–-CMCD373JE)H%tmrJ1.T2qKk-xa~a
0
XT(z)
T. FXZIRO$I. L%T. HlJu)4iLEkT'4j-x F74/Y-
ZE~Lj&UT. /Y%)l/z?fi L~T. 4$4'(?)X ~–fi-n=y
b@~X%+Eit!O\ XP–ti-ZZy FH$LT<E2k3.
Remove the grill frame and four pieces fo rubber caps by pulling
out with a flat-bladed screwdriver. Remove the screws from hole
where installed rubber caps. Insert a flat-bladed screwdriver into
the position indicated by the arrows and remove the panel. Re-
move the screws of each speaker unit and then remove the speaker
units.
Type.3
HtJIZ-WZE?KY--f
TX F 9-f) T- ES LiAhT. )T*)LW?.
L%z7. +$a(nx~–fi-z=y F@ I!!ltcT'+j-X F?q'
)T—%%LiNuT, Ef%H$I%KEIt!G2@x E—h—xz. y
b ?M+LT< jYSU~oX E-fi-a=y lxZj$!@M+#%I%I
C9 IJ Y3'i&3V_6%T. lEliE5i3YlTj!J+jij%~o
Insert a flat-bladed screwdriver into the position indicated by the
arrows and remove the panel. Turn the speaker unit to counter-
clockwise direction while inserting a flat-bladed screwdriver into
one of the hollows around speaker unit, and then remove the speaker
unit. After replacing the speaker unit, install it turning to clockwise
direction until "click" sound comes out.
62