Verifying That The Heart Rate Display Is Operational - Precor CLM 835 Assembling And Maintaining Manual

Climber

Hide thumbs Also See for CLM 835:

Table of Contents

4. Line up the two small tabs at the bottom of the console's

5. Insert the two #8–32 x ¹ ₂-inch Phillips-head screws that

6. Fully tighten the four mounting screws (partially

Verifying That the Heart Rate Display Is

Operational

To verify that the heart rate display is operational:

2. Grasp both touch-sensitive handlebars.

3. Look at the HEART RATE display. After a few seconds, a

4. If a number does not appear in the HEART RATE display,

back cover with the slots at the bottom of the console

case. Insert the tabs into the slots.

you removed earlier into the holes at the top edge of the

console's back cover. Tighten the screws fully.

Important: Use caution not to pinch the cables between the

back cover and PVS mounting screw heads.

tightened in step 3) using a ⁵ ₃₂-inch hex wrench.

Begin exercising on the equipment.

Note: The heart rate is read within ten seconds. During

that time, the heart on the display flashes. You must

maintain contact with both metal plates on each

handlebar to ensure an accurate reading.

number appears indicating your heart rate.

perform the following checks:

–

Verify that the cable connection is properly

connected.

–

Repeat the test with a different person. Although the

heart rate display is generally highly accurate, it may

not work properly for a few individuals.

Note: If you use wireless heart rate monitoring, repeat

this test using a chest strap or a wireless pulse simulator

instead of grasping the touch-sensitive handlebars.

Assembling and Maintaining the CLM 835 Climber

Table of Contents