Printing And Cutting Positions; Paper Specifications - Epson TM-T70-i Technical Reference Manual

Printing and Cutting Positions

Manual-cutter position
Autocutter blade position
Center of the print dotline
The values above may vary slightly as a result of paper slack or variations in the paper.
Take the notice into account when setting the cutting position of the autocutter.

Paper Specifications

Paper type
Size Roll paper diameter
Roll paper spool
Take-up roll paper width
Paper width
Specified roll paper type
 Paper must not be pasted to the roll paper spool.
 The remaining amount of the roll paper when a roll paper near-end is detected differs
depending on the spool type.
Approx. 15
[units: mm (All the numeric values are typical.)]
Specified thermal paper
83 mm {3.27"} maximum
Inside: 12 mm {0.47"}, Outside: 18 mm {0.71"}
80 + 0.5/-1.0 mm
79.5 ± 0.5 mm
NTP080-80
In U.S.A.: Nakagawa Mfg. (USA) Inc.
In Europe: Nakagawa Mfg. (Europe) GmbH
In Southeast Asia: N.A.K. Mfg. (Malaysia) SDN BHD
(Original paper: TF50KS-E Nippon Paper Industries Co., Ltd.Åj
Chapter 1 Product Overview
Approx. 30
Paper feed direction
1
31