Tecumseh OHV 110 Operator's Manual page 13

B. Removing Debris from Engine
Before each use, remove grass clippings, dirt and debris
from the following areas:
• Levers and Linkage
• Cooling Fins
• Air Intake Screen
• Air Inlet
• Guards
Removing debris will insure adequate cooling, correct
engine speed and reduce thhe risk of fire. See Figure 20.
Before removing air cleaner cover see "III. Filter Removal/
Installation" instructions on page 12. Special care should be
taken to prevent damage when removing air cleaner cover.
See Figure 20.
DO NOT bend levers and linkage with fingers. See Figure
21.
1. See "III. Filter Removal/Installation" instructions on
page 12.
2. Remove Air Cleaner Cover and filters. See Figure 20.
3. Remove debris from air inlet, air cleaner cover and air
intake screen.
4. Inspect filter(s) for discoloration or dirt accumulation. If
either is present, See "I. Servicing Foam Pre-Filter"
instructions on page 12. See "II. Servicing Paper Fil-
ters" instructions on page 12.
5. Replace Air Cleaner Cover and Filters.
C. Spark Plug
Check spark plug yearly or every 100 operating hours.
1. Clean area around spark plug.
2. Remove and inspect spark plug.
3. Replace spark plug if porcelain is cracked or if elec-
trodes are:
• Pitted
• Burned
• Fouled with deposits
4. Check electrode gap with wire feeler gauge and set
gap to .030 (0.76mm) if necessary. See Figure 22.
5. Install spark plug and tighten securely.
A resistor spark plug must be used for replacement. Contact
your Authorized Tecumseh Servicing Dealer for a
Tecumseh Resistor Spark Plug.
181-1132-14
NOTE
NOTE
Four-Cycle • Vertical Crankshaft • Air-Cooled
5
1. Cooling Fins
2. Levers and Linkage
3. Air Inlet
4. Air Cleaner Cover
5. Air Intake Screen
Figure 20. Debris Locations
Figure 21. Linkage and Lever Bending
2
1
1. .030 (0.76mm) Gap
2. Electrodes
3. Porcelain
Figure 22. Spark Plug
4
3
1 2
3
Page 11