Table of Contents
Advertisement
12/06/22 14:17:57 31KYKA00_109
Wheels
RIGHT REAR
(10)
(8) lug
(9) slot
(10) brake panel
100
Servicing Your Honda
Installation
1.
Reverse the removal procedure. Make sure
the lug ( ) on the swingarm is located in the
8
slot ( ) in the brake panel ( ). Check that
9
the chain adjusters are installed properly.
2.
Adjust the drive chain (page
3.
Torque the rear axle nut to:
47 lbf·ft (64 N·m , 6.5 kgf·m)
4.
Adjust the rear brake (page
(8)
5.
Apply the rear brake, release it, then spin the
(9)
wheel and check that it rotates freely. Repeat
this procedure several times.
If a torque wrench was not used to install the
wheel, see your dealer as soon as possible to
verify proper assembly. Improper assembly
may lead to loss of braking capacity.
10
109
).
92
).
Hide quick links:
Advertisement
Chapters
Table of Contents
