To Load The Latest Presets Into Your Dx2 - Martin Audio DX2 Software Manual

You will need a 9 pin male-to-female, fully wired, pin-to-pin RS232 cable (not the
null modem type).

To load the latest presets into your DX2

1) Connect the 9-pin male to 9-pin female DEE type serial lead from your
computer to the external socket on the back of the unit. Note: this lead should be
pin-to-pin - not be of the null modem type.
2) On the DX2 use the blue Menu, Back,
Interface Sub-menu and then into External Interface.
3) Once entered, setup as follows:
Mode:
Wiser Wireless:
Serial Speed:
Stop MIDI Prog,Chng:
Remote ID Number:
Press Enter to confirm
4. Run the programme MartinFlashLoader.exe.
Click Load New Preset File.
All material © 2007. Martin Audio Ltd. Subject to change without notice.
Next and
RS232 Mode
No
As required (e.g. 115200)
Yes
1
Enter keys to go into the