Baby Lock Soprano BLMSP Instruction And Reference Manual page 124

Troubleshooting
f Remove the needle plate cover.
1 Needle plate cover
• Refer to "Cleaning the race" on page A-2.
g Cut out the tangled threads, and then remove the
bobbin.
h Remove the bobbin case.
If threads remain in the bobbin case, remove them.
1 Bobbin case
i Use the cleaning brush or a vacuum cleaner to remove
any lint or dust from the race and its surrounding area.
1 Cleaning brush
2 Race
If the fabric could be removed.
If the fabric could not be removed.
A-8
j
1
k
l
m
n
o
p
Continue with step .
j
Continue with step .
Use the included L-shaped (or disc-shaped)
screwdriver to loosen the two screws on the needle
plate.
Note
• Be careful not to drop the removed screws in the
machine.
Slightly lift up the needle plate, cut any tangled
threads, and then remove the needle plate.
Remove the fabric and threads from the needle plate.
If the fabric cannot be removed, even after completing
these steps, contact your nearest authorized Baby Lock
retailer.
Remove any threads in the race and around the feed
dogs.
Turn the handwheel to raise the feed dogs.
Align the two screw holes in the needle plate with the
two holes at the needle plate mounting base, and then
fit the needle plate onto the machine.
Lightly finger-tighten the screw on the right side of the
needle plate. Then, use the L-shaped (or disc-shaped)
screwdriver to firmly tighten the screw on the left side.
Finally, firmly tighten the screw on the right side.