The Event Log After Every Logon To Windows 2000 Includes The Following Error Log; The Os Presents Unstable Operation; The System Does Not Restart Automatically When A Stop Error Occurs, Though The System Is Adjusted To Automatically Restarting; The System Restarts Automatically When A Stop Error Occurs, Though The System Is Not Adjusted To Automatically Restarting - NEC Express 5800 120Eg User Manual

Is the OS broken?
- Use recovery process to recover the system. (See
System" on page 5-36

The event log after every logon to Windows 2000 includes the following error log:

Description (D)
The CPUs in this multiprocessor system are not all the same revision level.
To use all processors the operating system restricts itself to the features of
the least capable processor in the system. Should problems occur with
this system, contact the CPU manufacture to see if this mix of processors
is supported.
Has the CPU been expanded?
- If the different revision (stepping) of the processor is installed in the multipro-
cessor system, Windows 2000 logs the above information every startup. If this
message is logged, it is no problem for operation.

The OS presents unstable operation:

Did you update the system?
- Installing a network drive after installation of the OS may cause unstable opera-
tion. Use the NEC EXPRESSBUILDER CD-ROM to update the system. (See
"Updating the System" on page D-18
The system does not restart automatically when a stop error occurs, though the
system is adjusted to automatically restarting:
- When the system does not restart automatically, restart it manually.
The system restarts automatically when a stop error occurs, though the system is
NOT adjusted to automatically restarting:
- There is no problem about this issue.
Check the System Event Log to confirm that STOP error occurred.

Cannot turn the power OFF at the blue screen:

- If you want to turn off the power at the blue screen, execute forced shutdown
(forced shutdown: continue to press POWER switch for 4 seconds). The power
will not be turned off if you press the switch for less than 3 seconds.

The server is not found on the network:

Is the LAN cable connected?
- Make sure to connect the LAN cable to the network port on the rear of the
server. Also make sure that the LAN cable to use conforms to the network
interface standard.
120Eg User Guide - Problem Solving
.)
.)
5 - 26
"Recovery for Windows 2000