Computer Input Source Selection - Sanyo PLC-HF15000L Owner's Manual

Input Selection
Menu Operation
1
Press the MENU button to display the On-Screen
Menu. Use the Point
then press the Point
2
Use the Point
and then press the Point
submenu items.
3
Use the Point
source and then press the SELECT button.
Note:
•"Input 3" and/or "Input 4" are selectable only when interface
board(s) are connected to either or both of the slots.
WHEN SELECTING INPUT 1
(COMPUTER INPUT TERMINALS )
RGB(PC analog)
When your computer is connected to the INPUT 1
(ANALOG) terminal, select RGB (PC analog).
Note:
• Input source changes if the INPUT 1 button on the remote
control is pressed.
WHEN SELECTING INPUT 2 (5 BNC INPUT JACKS )
When connecting the computer output [5 BNC Type (Green,
Blue, Red, Horiz. Sync, and Vert. Sync.)] from the computer
to G, B, R, H/HV, and V jacks:
RGB
When your computer is connected to the INPUT 2 (5
BNC INPUT JACKS) terminal, select RGB.
34

Computer Input Source Selection

buttons to select Input and
or the SELECT button.
buttons to select the desired input
button to access the
buttons to select the desired
INPUT MENU
INPUT 2 MENU