Setting The Pc Audio; Setting The Sleep Timer - Toshiba 19AV500U Owner's Manual

:;~··-1 :1f':~:~~9ii:~~;'!fj~>"~~·.'~rm'rl~~:il!r'~~~~~'i)~~~~ff1~' '~l ~ r.' ~ t ~~:;~~~:lr~::;~0~~~e~W!"f(
.- Chapter 6: Us/ngthe
TV~
features
• H-Position:
Moves the picture left/right.
The adjustment range is -50-+50 (default value is 0). *
• V-Position:
Moves the picture up/down.
The adjustment range is -10-+10 (default value is 0).*
• Clock:
Helps to reduce noise and sharpen the picture.
The adjustment range is -10-+ 10 (default value is 0). *
• Phase:
Helps to reduce noise and minimize periodic vertical
stripes on the screen.
The adjustment range is -15-+16 (default value is 0).*
*
The default settings may vary depending on the input signal
format.
Setting the PC Audio
If the INPUT source is set to Pc. The PC IN audio phone jack
is applied for PC IN when PC IN terminal is connecting with
an analog RGB cable. (~page 18)
Setting the sleep timer
You can set the sleep timer to tum off the TV after a set
length of time (maximum of 90 minutes).
To set the sleep timer using the remote control:
Press
S~EP
on the remote control to set the length of time until
the TV turns off. Repeatedly press
S~EP
to increase the time in
30-minute increments, to a maximum of 90 minutes.
To set the sleep timer using the on-screen menus:
1 Press M~U and open the Prefer menu.
2
Highlight Sleep Timer.
3 Press ~ or
@
to increase the time in 30-minute
increments.
Off~30 Min~60 Min~90 Min~Off
Note: When a power failure occurs, the sleep timer setting
may be cleared.
To display the remaining sleep timer:
Press
S~EP
on the remote control or same as above process
using the on-screen menus.
Note: Because the PC Audio input is shared with HOM/.
If INPUT source is set to "HDMI , "And the HDMI signal is
OV/ format. This PC Audio input will apply for HOMI. (Also
see item 2 on page 11.)
60 min Left
~
To cancel the sleep timer:
Repeatedly press
S~EP
until it is set to Off.
41
I