Trouble Shooting - Cover Hems - ELNA 745 Service Manual

1. If "L0 or L1" needle thread is being pulled to the right (Fig.1), then check the following
points:
2. Insert new needles (No. 90) .
3. Check and make sure that needles are correctly inserted into the needle clamp.
4. Check and make sure that the needle (L0 or L1) is not touching the needle plate holes. If
necessary, check adjustment on page 3. "Height and orientation of needle bar in relation to
the needle plate holes".
ANNEX

TROUBLE SHOOTING - COVER HEMS

- cover hems stitch being pulled -
L0
L1
Blue
Red
Fig.1
a