Local Dimming Function Check; Outgoing Condition Configuration; Gnd & Hi-Pot Test; Gnd & Hi-Pot Auto-Check - LG 32LN5400 Service Manual

(10) FHD 2D DTS EDID Data (Not Support Deep Color – 8bit)
CheckSum
HDMI 1 42/8C
HDMI 2 42/7C
- HDMI

4.5. Outgoing condition Configuration

■ When pressing IN-STOP key by SVC remocon, Red LED
are blinked alternatively. And then automatically turn off.
(Must not AC power OFF during blinking)
4.6. GND & Hi-pot test
4.6.1. GND & HI-POT auto-check preparation
(1) Check the POWER CABLE and SIGNAL CABE insertion
condition
4.6.2. GND & HI-POT auto-check
(1) Pallet moves in the station. (POWER CORD / AV CORD is
tightly inserted)
(2) Connect the AV JACK Tester.
(3) Controller (GWS103-4) on.
(4) GND Test (Auto)
- If Test is failed, Buzzer operates.
- If Test is passed, execute next process (Hi-pot test).
(Remove A/V CORD from A/V JACK BOX)
(5) HI-POT test (Auto)
- If Test is failed, Buzzer operates.
- If Test is passed, GOOD Lamp on and move to next
process automatically.
Copyright © LG Electronics. Inc. All rights reserved.
Only for training and service purposes
Physical Address (0x9E)
10
20
- 17 -
4.6.3. Checkpoint
(1) Test voltage
① 3 Poles
- GND: 1.5KV/min at 100mA
- SIGNAL: 3KV/min at 100mA
② 2 Poles
- SIGNAL: 3KV/min at 100mA
(2) TEST time: 1 second
(3) TEST POINT
① 3 Poles
- GND Test = POWER CORD GND and SIGNAL CABLE
GND.
- Hi-pot Test = POWER CORD GND and LIVE & NEUTRAL.
② 2 Poles
- Hi-pot Test = Accessible Metal and LIVE & NEUTRAL.
(4) LEAKAGE CURRENT: At 0.5mArms

5. Local Dimming Function Check

Step1) Turn on TV.
Step2) Press "P-only" key, enter to power only mode and
escape the "P-only" Mode by pressing "Exit" key
Step3) Press "Tilt" key, entrance to Local Dimming mode.
Step4) At the Local Dimming mode, module Edge Backlight
moving Top to bottom Back light of module moving
Step5) confirm the Local Dimming mode
Step6) Press "Exit" key
LGE Internal Use Only