Clock And Timers; External Equipment - Panasonic SC-AKX600 Operating Instructions Manual

Clock and timers

Setting the clock
This is a 24-hour clock.
1
Press [SETUP] to select "CLOCK".
2
Press [Y, U] to set the time and then press [OK].
To check the time
Press [SETUP] to select "CLOCK" and then press [OK].
In standby mode, press [DISPLAY].
Note:
Reset the clock regularly to maintain accuracy.
Sleep timer
The sleep timer switches off the system after the set time.
Press [SLEEP] to select the setting (in minutes).
"SLEEP" is shown.
To cancel, select "OFF".
To check the remaining time
Press [SLEEP].
Note:
•
The play timer and sleep timer or the record timer and sleep
timer can be used together.
• The sleep timer always comes first. Be sure not to set an
overlap of timers.
Play timer and record timer
(Except for Bluetooth
You can set the timer to come on at a certain time to:
• Wake you up (play timer).
• Record from the radio (record timer).
Play timer and record timer cannot be used together.
Preparation
Set the clock.
1
Press [SETUP] to select "TIMER ADJ".
2
Press [Y, U] to select "#PLAY" or "#REC" and
then press [OK].
3
Press [Y, U] to set the start time and then press
[OK].
4
Do step 3 again to set the end time.
5
Press [Y, U] to select the source you want to play
or record and then press [OK].
6
For record timer, press [Y, U] to select "MEMORY"
or "USB B" to keep the recording and then press
[OK].
14
, AUX 1 and AUX 2 source)
®
To start the timer
1
Prepare the source.
Play timer Prepare the source you want to listen
to (disc, USB, internal memory or
radio) and set the volume.
Record timer Connect the USB device to
USB recording) and tune in to the
radio station.
2
Press [SETUP] to select "TIMER SET".
3
Press [Y, U] to select the setting and then press
[OK].
PLAY ON Start the play timer. "#PLAY" is
shown.
PLAY OFF Cancel the play timer.
REC ON Start the record timer. "#REC" is
shown.
REC OFF Cancel the record timer.
The system must be switched off for the timer to
operate.
To check the setting
1
Press [SETUP] to select "TIMER ADJ".
2
Press [Y, U] to select "#PLAY" or "#REC" and
then press [OK].
In standby mode, press [DISPLAY] two times.
Note:
•
The play timer starts at a low volume and increases
gradually to the preset level.
•
The record timer starts 30 seconds before the set time with
the volume muted.
•
The timer comes on at the set time every day if the timer is
on.
•
If you switch off the system and then switch on again while
a timer is in operation, the timer will not stop at the end
time.

External equipment

Preparation
• Disconnect the AC mains lead.
• Switch off all equipment and read the appropriate
operating instructions.
Note:
Components and cables are sold separately.
(for
USB B