Sanyo VPC-S122EXBL Service Manual page 17

4. CCD Black Point And White Point Defect Detect
Adjustment In Lighted
Camera
Preparation:
POWER switch: ON
Setting of pattern box:
Color temperature: 3100 ± 20 (K)
Luminance: 900 ± 20 (cd/m
Adjusting method:
1. Set a distance of 0.5-1.0 cm between the pattern box and
the camera when zoom wide edge.
2. Double-click on the DscCalDi.exe.
3. Select "CCD Black" on the LCD "Test", and click the "Yes".
4. After the adjustment is completed, the number of defect
will appear.
5. Click the OK.
Pattern box
(color viewer)
2
)
3-9. Factory Code Setting
1. Check the "Factory Code" display within the Setting group.
2. For U.S.A., Canada and NTSC general area
If "FC_SANYO_U" does not appear, click on the "
located on the right of the "Factory Code" display BOX and
select "FC_SANYO_U".
3. For Europe and PAL general area
If "FC_SANYO_EX" does not appear, click on the "
located on the right of the "Factory Code" display BOX and
select "FC_SANYO_EX".
3-10. Language Setting
1. Click on the " " mark located on the right of the
"Language" display BOX.
2. Select language. (Default is English.)
3. End "DscCal" and remove the camera before turning the
camera power OFF.
Calibration Upload
AWB
Firmware
Focus
Data
UV Matrix
Cal Mode
Initialize
OK
EVF
Cal Data
LCD Type
OK
USB storage
VID
Get
PID
Set
Backrush pulse :
Get
3-11. Reset Setting
Carry out reset settings after replacing CP1 board.
1. Turn on the camera.
2. Double-click on the DscCalDi.exe.
3. Select "Set Default" on the LCD "Test".
3-12. The Compulsive boot starting method
1. Keep SET button and SHUTTER button depressed while
switching on the power.
2. Connect the camera and the computer with USB cable.
– 17 –
LCD
R Bright B Bright
RGB Offset Gain
Tint Phase
VCO
H AFC Test
Set Serial Set
Set Rev.
Set
Set
" mark
" mark
VCOMDC
VCOMPP
Hall Cal.
Setting
Language
Video Mode
Factory Code