Status - Samsung SCU-2370 User Manual

Camera Default Set : (SCU-2370)
This mode can be used if the camera module has been
replaced and you want to keep the camera's existing settings
for the new module.
To reset the camera, first replace the old module with a new
camera module. When the replacement is properly installed,
turn on the module, then execute this command.

STATUS

Displays the settings and version of the camera.
CAMERA INFO :
Display the model and zoom factor of the connected camera.
CAMERA VER. :
Display the software version of the connected camera.
MOTION VER. :
Main board F/W version
PROTOCAL :
Protocol settings
CONTROLLER :
Communication mode settings
INNER VER. :
Inner board F/W version
DRIVER VER. :
Display the DSP F/W version of the main board.
Initialize
▶ Power On Reset
Factory Default Set
Camera Default Set
Main Menu
Camera Setting
Sequence Setting
P/T Setting
OSD Setting
Alarm Setting
Initialize
▶ Status
Status
CAMERA INFO. = SCM2370/NTSC
CAMERA VER. = V2.00_100527
MOTION VER. = V1.00_100726
PROTOCOL = SAMSUNG-T
CONTROLLER = S-9600
INNER VER. = V1.00_100726
DRIVER VER. = V1.00_100726
English - 59