Table of Contents
Advertisement
MAINTENANCE
4. Replace the C-cast baffle and tubes. After the tubes are
in place check to see that the c-cast baffle is slid back
against the steel non- removable baffle. Replace the
rear bricks.
ClEANINg YOuR ChIMNEY
The Challenger VSW20 stove has a removable baffle which
allows the chimney to be cleaned without removing the
connector from the stove.
Make sure the stove is cool before proceeding
Figure 18 a & b -
Remove Baffle
ST1062
To remove the rear of the baffle, reach in through the door
and lift up on the rear half of the baffle and, very carefully
SSW20 remove baffle
with your fingers, walk the rear half of the baffle up and
onto the front half of the baffle. Make sure you slide it far
enough forward so the chimney brush will not damage it
when cleaning. Figure 18a. There is no need to remove
the secondary air tubes for cleaning.
After the chimney has been cleaned clean out the firebox
and carefully replace the rear half of the baffle. Check to
see that both pieces of the baffle are down on the steel
baffle and pushed all the way to the rear of the firebox.
Figure 18b
20300059
CREOSOTE
When wood is burned slowly, it produces tar and other
organic vapors. These combine with moisture to form
creosote. Creosote vapors condense in the relatively cool
chimney flue of a slow burning fire. As a result, creosote
residue accumulates on the flue lining. When ignited,
this creosote makes an extremely hot fire. The chimney
should be inspected regularly during the heating season to
determine if a creosote build-up has accumulated. If this
is the case, the creosote should be removed to reduce the
risk of chimney fire.
WARNINg:
Things to remember in case of chimney fire:
1. ClOSE dRAFT CONTROl
2. CAll ThE FIRE dEpARTMENT
kEEp uNIT FREE OF CREOSOTE
1. Burn with air control open for several minutes at
numerous intervals throughout the day during the
heating season, being careful not to over-fire unit. This
removes the slight film of creosote accumulated during
low burn periods.
2. Burn stove with draft control wide open for several
minutes every time you apply fresh wood. This allows
wood to achieve the charcoal stage faster and burns
wood vapors which might otherwise be deposited within
the systems.
3. BURN ONLY SEASONED WOOD. Avoid burning wet
or green wood. Seasoned wood has been dried for at
least one year.
4. A small hot fire is preferable to a large smoldering one
that can deposit creosote within the system.
5. Establish a routine for the fuel, wood burner and firing
technique. Check daily for creosote build-up until
experience shows how often you need to clean to be
safe. Be aware that the hotter the fire, the less creosote
is deposited and weekly cleaning may be necessary
ST1062
in mild weather even though monthly cleaning may
be enough in the coldest months. Contact your local
municipal authority for information on how to handle a
chimney fire. Have a clearly understood plan to handle
a chimney fire.
ASh dISpOSAl
Ashes should be placed in a metal container with a tight-
fitting lid. The closed container of ashes should be placed
on a non-combustible floor or on the ground, well away
from all combustible materials, pending final disposal. If
the ashes are disposed of by burial in soil or otherwise
locally dispersed, they should be retained in the closed
container until all cinders have thoroughly cooled. Other
waste should not be placed in the ash container.
VSW20 Wood Stove
19
Advertisement
Table of Contents
