Table of Contents
Advertisement
4. Method to reduce the gap between the door seal and the oven front surface.
(1) To reduce gap located on part A.
Loosen a screw on stopper hinge top, and then push the door to
contact the door seal to oven front surface.
Tighten a screw.
(2) To reduce gap located on part B.
Loosen two screws on stopper hinge under, and then push
the door to contact the door seal to oven front surface.
Tighten two screws.
NOTE
A sm all gap m ay be acceptable if the m icrow ave leakage does not exceed 4m W /cm
DISASSEMBLY AND ASSEMBLY
2
.
Advertisement
Table of Contents
