Amana GMSS9 Series Service Instructions Manual page 12

PRODUCT IDENTIFICATION
MODEL # MFG #
DCVK-20
(CVENT-2)
DCVK-30
(CVENT-3)
EFR02
0170K00000S
0170K00001S
LPLP03
LPM-07
RF000142
12
Concentric Vent Kit. This kit is designed to allow terminations of a direct vent furnace
N/A to be "concentrically" vented through a wall or roof. This kit allows a single penetration
to support terminations for both the vent/flue and the com bustion air intak
External Filter Rack Kit. For use with 34.5" up flow gas furnaces. This kit is intended to
N/A provide a location, external to the furnace casing for installation of a permanent filter.
The rack is mounted over the indoor air blower compartment area of either
Side Wall Only Concentric Vent Kit. This kit is to be used with 2" - 3" vent systems.
N/A The vent kit must terminate outside the structure. This kit is NOT intended for use with
single pipe (indirect vent) installations.
Side Wall Only Concentric Vent Kit. This kit is to be used with 2" vent systems. The
N/A vent kit m ust terminate outside the structure. This kit is NOT intended for use with
single pipe (indirect vent) installation
LP Gas Low Pressure Kit. Designed for use with furnaces converted to LP gas. The kit
N/A m onitors gas line pressure with a pressure switch and will open the circuit to the gas
valve if the LP tank pressure gets low.
LP Conversion Kit Converts a 34.5" single stage furnace to operate on L.P. gas. The
N/A
kit contains an L.P. gas valve and a set of six L.P. orifices.
Drain Coupling Kit For use when the drain/vent elbow has been rem oved in a
horizontal left installation. This kit prevents condensate from getting in the inducer and
N/A
routes the condensate to a drain. This kit can also be used on the furnace combustion
air inlet to catch condensate.
DESCRIPTION