Table of Contents
Advertisement
About the AC adaptor/battery
charger
≥ If the temperature of the battery is extremely
high or extremely low, charging may take time
or the battery may not be charged.
≥ If the charging lamp keeps flashing, make
sure that the terminals of the battery or the
battery charger are not exposed to dirt,
foreign objects or dust, then reconnect them
properly.
Disconnect the AC cable from the AC outlet
when you remove dirt, foreign objects or dust
on the terminals of the battery or the battery
charger.
If the charging lamp is still flashing, the
temperature of the battery may be extremely
high or extremely low or something may be
wrong with the battery or battery charger.
Contact your dealer.
≥ If you use the AC adaptor or battery charger
near a radio, radio reception may be
disturbed. Keep the AC adaptor or battery
charger 1 m (3.3 feet) or more away from the
radio.
≥ When using the AC adaptor or battery
charger, it may generate whirring sounds.
However, this is normal.
≥ After use, be sure to disconnect the AC cable
from the AC outlet. (If you leave this unit
connected, the AC adaptor will consume
approximately 0.3 W and the battery charger
approximately 0.3 W of current.)
≥ Always keep the electrodes of the AC
adaptor, battery charger and battery clean.
≥ Install the device near an AC outlet so
that the power disconnection device
(AC mains plug) can be accessed
easily by hand.
46
SQT1040
About the SD card
When disposing of or giving away the SD
card, note that:
≥ Formatting and deletion of this unit or
computer only changes the file management
information and does not completely delete
the data in the SD card.
≥ It is recommended that the main SD card is
either physically destroyed or the SD card is
physically formatted using this unit when
disposing of or giving away the SD card.
≥ To physically format, connect this unit to the
AC adaptor, select [OTHER FUNCTION] #
[FORMAT MEDIA] # [SD CARD 1] or [SD
CARD 2] from the menu, and touch [YES].
Press and hold recording start/stop button in
the following screen for three seconds.
Screen to delete the SD card data is
displayed, so select [YES] and follow the
instruction on the screen.
≥ The customer is responsible for the
management of the data in the SD card.
Advertisement
Table of Contents
