What To Do If - Zanussi ZTE 273 User Manual

What to do if ...

Troubleshooting by yourself
Problem
Dryer does not work.
Drying results unsatisfactory.
When a button is pressed - no
reaction of the machine.
Programme inactive, Bac plein
(Water Reservoir) light up.
Drying cycle ends shortly after
programme starts. Anticrease/
End light up.
Drying cycle lasts an unusually
long time. Note: After up to 5
hours the drying cycle ends au-
tomatically (see 'End of drying
cycle').
12
Possible cause
Mains plug is not plugged in or fuse is
not working correctly.
Loading door is open.
Have you pressed the Marche/Arrêt
(Start/Pause) button?
Wrong programme selected.
Lint filters clogged.
Fluff filter clogged.
Heat exchanger clogged with lint.
Overloading of laundry.
Ventilation slots in base area covered
up.
Residue on inside surface of drum or
drum ribs.
Conductance of water at installation
site differs from standard setting of ma-
chine.
Drying protection. After the start of the
programme, the option can no longer
be set.
Condensate tank is full.
Not enough washing loaded or washing
loaded is too dry for selected pro-
gramme.
Lint filter clogged.
Fluff filter clogged.
Load volume too big.
Remedy
Plug in at mains socket. Check fuse in
fuse box (domestic installation).
Close loading door.
Press the Marche/Arrêt (Start/Pause)
button again.
Select a different programme the next
time you dry (see "Programme over-
view" chapter).
Clean lint filters.
Clean fluff filter.
Clean heat exchanger.
Observe recommended loading vol-
umes.
Uncover ventilation slots in base area.
Clean inside surface of drum and drum
ribs.
Re-programme standard setting for de-
gree of drying (see 'Programming op-
tions' chapter).
Turn the programme knob to O
the programme again.
Empty condensate tank, then start pro-
gramme with Marche/Arrêt (Start/
Pause) button.
Select time programme or higher dry-
ing level (e.g. Très sec (Extra Dry) in-
stead of Prêt à ranger (Cupboard Dry)
Clean lint filter.
Clean fluff filter.
Reduce load volume.
off
. Set