Set Ethernet Mode; Set Friendly; Set Ip; Set Location - AMX SDX-510M-DX Instruction Manual

Appendix A - Telnet (Terminal) Commands
Telnet Commands (Cont.)
Command

SET ETHERNET MODE

SET FRIENDLY

SET IP

SET LOCATION

52
Description
This command sets the current LAN configuration settings per new mode.
Syntax:
SET ETHERNET MODE <newmode>
Values for newmode are:
auto
Or
10 full, 100 full, 10 half, or 100 half
Note: This command requires a reboot to enable new settings.
Examples:
set ethernet mode auto
set ethernet mode 100 full
Set the device's friendly name for NDP to <name>.
Syntax:
SET FRIENDLY <name>
• Maximum length = 25 characters. If the name entered exceeds 25 characters, it will be
truncated.
• The value is stored in non-volatile memory.
• If no value specified, an automatic name consisting of AMX, the product name, and
serial number will be used.
Note: This command requires a reboot to enable new settings.
Sets the IP configuration of a specified device.
Enter a Host Name, Type (DHCP or Fixed), IP Address, Subnet Mask, and Gateway IP
Address.
Important: Host Names may only contain ASCII letters "a" through "z" (not case-
sensitive), digits "0" through "9", and the hyphen ("-").
Note: Note: DHCP implies "DHCP with link-local fallback".
Note: Note: For NetLinx Masters, the Host Name can only consist of alphanumeric
characters.
• Enter Y (yes) to approve/store the information on the Master.
• Enter N (no) to cancel the operation.
Note: This command requires a reboot to enable new settings.
Example:
>SET IP
--- Enter New Values or just hit Enter
to keep current settings ---
Enter Host Name: DXL-RX-36d0110
Enter IP type. Type D for DHCP or S for Static IP and
then Enter: DHCP
You have entered: Host Name
Type
Is this correct? Type Y or N and Enter -> y
Settings written. Device must be rebooted to enable
new settings.
Note: The switcher can also be set to Static IP or DHCP Mode via the front panel ID
Pushbutton.
Sets the location parameter for NDP.
Syntax:
SET LOCATION <location>
Maximum length = 25 characters. If the name entered exceeds 25 characters, it will be
truncated.
Note: This command requires a reboot to enable new settings.
DXL-RX-36d0110
DHCP
Instruction Manual - Solecis Digital Switchers