Yaesu FT-8800R Technical Supplement page 15

49. Press the "Left" band [ V/M ] key.
50. Tune the "Left" band frequency to 850.05 MHz.
51. Inject an 850.05 MHz signal at a level of +3 dBµ from
the RF Signal Generator.
52. Press the "Left" band [ LOW ] key.
53. Increase the RF Signal Generator output level to +31
dBµ.
54. Press the "Left" band [ V/M ] key.
DC Voltmeter
1. Set the power supply voltage to 13.8 VDC.
2. Press and hold in the in the "Sub" band DIAL knob to
set the Alignment parameter to "b-8 BAT SC."
3. Press the "Left" band [ SCN ] key.
To close the Alignment mode, just press and hold in the
"Right" VOL knob for 2 seconds (to turn the power off).
The next time the transceiver is turned on, normal opera-
tion may resume.
Alignment
15