Programming Channel Memory; Programming Channels Automatically - Toshiba 52HMX84 Service Manual

PROGRAMMING CHANNEL MEMORY

Adding channels to the TV's memory
When you press Channel y or z, your TV will stop only on the
channels stored in the TV's channel memory.
Follow the steps below and on the next page to program all active
channels into the TV's memory.

Programming channels automatically

Your TV can automatically detect all active channels in your area and
store them in its memory. After the channels are stored automatically,
you can manually add or erase individual channels.
To program channels automatically:
1. Press MENU, and then press x or • until the SET UP menu
appears.
2. Press y or z until TV/CABLE is highlighted, and then press
ENTER to display the pull-down menu.
3. Press y or z to highlight either TV or CABLE, depending on
which you use. If you use an antenna, highlight TV; if you use
cable channels, highlight CABLE.
SET UP
LANGUAGE
CLOCK SET
ANT 1 / 2
TV / CABLE
CH PROGRAM
ADD / ERASE
: S E L E C T ENTER : SET
4. Press ENTER.
5. Press z to select CH PROGRAM.
SET UP
LANGUAGE
CLOCK SET
ANT 1 / 2
TV / CABLE
CH PROGRAM
ADD / ERASE
: MOVE ENTER : START
6. Press ENTER to start channel programming. The TV will
automatically cycle through all the TV or Cable channels
(depending on which you selected), and store all active channels
in the channel memory.
While the TV is cycling through the channels, the message
"Programming Now—Please Wait" appears.
7. When channel programming is complete, the message
"Completed" appears.
8. Press Channel y or z to view the programmed channels.
T V
C A B L E
E N G L I S H
0 0 : 0 0
ANT1
CABLE
ADD
- 11 -
Note:
To tune the TV to a channel not programmed
in the channel memory, you must use the
Channel Number buttons on the remote
control.
POWER
TV
LIGHT SLEEP
CABLE/SAT
VCR
1 2 3
DVD
AUDIO1
4 5 6
AUDIO2
MODE
7 8 9
PIC SIZE
+10
0
100/
ENT
ACTION
MENU
MENU
FAV
ENTER
ENTER
yzx •
FAV
Channel yz
VOL
CH
EXIT
DVD CLEAR
DVD RTN
CH RTN INPUT RECALL MUTE
SLOW/DIR SKIP/SEARCH