IBM Eserver xSeries 335 Type 8676 Hardware Maintenance Manual And Troubleshooting Manual page 110

Note: See "System" on page 116 to determine which components should be replaced by a field service technician.
Error code/symptom
164 (Memory configuration changed.)
165 (Service Processor failure)
175 (Hardware error)
176 (Computer cover or cable cover was
removed without a key being used)
177, 178 (Security hardware error)
184 (Power-on password damaged)
185 (Drive startup sequence information
corrupted)
186 (Security hardware control logic failed) 1. Run the Configuration/Setup Utility program.
187 (VPD serial number not set.)
188 (Bad EEPROM CRC #2)
189 (An attempt was made to access the
server with invalid passwords)
196 (Microprocessor mismatch error)
201 (Memory test error.) If the server does
not have the latest level of BIOS installed,
update the BIOS to the latest level and
run the diagnostic program again.
229 (Cache error)
262 (DRAM parity configuration error)
289 (DIMM disabled by POST or user)
301 (Keyboard or keyboard controller
error)
303 (Keyboard controller error)
100
xSeries 335 Type 8676, Type 8830: Hardware Maintenance Manual and Troubleshooting Guide
FRU/action
1. Run the Configuration/Setup Utility program.
2. DIMM.
3. System board.
v System board
v System board
1. Run the Configuration/Setup Utility program.
2. System board.
1. Run the Configuration/Setup Utility program.
2. System board.
1. Run the Configuration/Setup Utility program.
2. System board.
1. Run the Configuration/Setup Utility program.
2. System board.
2. System board.
1. Set serial number in the Configuration/Setup Utility program.
2. System board.
1. Run the Configuration/Setup Utility program.
2. System board.
v Run the Configuration/Setup Utility program, and enter the
administrator password.
1. Move microprocessor in socket 1 to socket 2, and move
microprocessor in socket 2 to socket 1.
2. Microprocessor.
1. DIMM
2. System board
1. Microprocessor
2. Optional microprocessor (if installed)
1. Run the Configuration/Setup Utility program.
2. Battery.
3. System board.
1. Run the Configuration/Setup Utility program, if the DIMM was
disabled by the user.
2. Disabled DIMM, if not disabled by user.
3. System board
1. Keyboard
2. System board
v System board