Alcatel-Lucent 7210 SAS M OS Configuration Manual page 135

that are exclusive based on the frame format.
The no form of the command removes the previously entered etype field as the match criteria.
Default no etype
Parameters ethernet-type — The Ethernet type II frame Ethertype value to be used as a match criterion expressed
isid
Syntax isid value | value to higher-value
no isid
Context config>filter>mac-filter>entry>match
Description This command configures an ISID value or a range of ISID values to be matched by the mac-filter
parent. The pbb-etype value for the related SAP (inherited from the ethernet port configuration) or for
the related SDP binding (inherited from SDP configuration) will be used to identify the ISID tag.
When an isid statement is used in a match criteria the corresponding mac-filter can be applied only on
the egress side of a SAP/SDP binding. In order to be able to use an isid match criteria one needs to set
the mac-filter type attribute to isid. Once this configuration is performed only ISID match criteria are
allowed in the mac-filter.
The no form of this command removes the ISID match criterion.
Default no isid
value or higher-value — Specifies the ISID value, 24 bits. When just one present identifies a
value to higher-value — Identifies a range of ISIDs to be used as matching criteria.
src-mac
Syntax src-mac ieee-address [ieee-address-mask]
no src-mac
Context config>filter>mac-filter>entry
Description
Configures a source MAC address or range to be used as a MAC filter match criterion.
The no form of the command removes the source mac as the match criteria.
Default
no src-mac
Parameters ieee-address — Enter the 48-bit IEEE mac address to be used as a match criterion.
7210 SAS M Router Configuration Guide
in hexadecimal.
Values 0x0600 — 0xFFFF
particular ISID to be used for matching.
Values
HH:HH:HH:HH:HH:HH or HH-HH-HH-HH-HH-HH where H is a hexadecimal
digit
Filter Policies
Page 135