FujiFilm FinePix S5700 Owner's Manual page 188

Antennas
Outdoor Antenna Grounding -
If an outside antenna or cable system is connected to the video
product, be sure the antenna or cable system is grounded so as to
provide some protection against voltage surges and built-up static
charges. Section 810 of the National Electrical Code, ANSI/N FPA
No. 70, provides information with respect to proper grounding of the
mast and supporting structure, grounding of the lead-in wire to an
antennadischarge unit, size of grounding conductors, location of
antenna-discharge unit, connection to grounding electrodes, and
requirements for the grounding electrode.
Power Lines -
An outside antenna system should not be located in the vicinity of
overhead power lines or other electric light or power circuits, or
where it can fall into such power lines or circuits. When installing an
outside antenna system, extreme care shohld be taken to keep from
touching such power lines or circuits as contact with them might be
fatal.
Use
EXAMPLE OF ANTENNA GROUNDING AS PER
NATIONAL ELECTRICAL CODE
Ground
Clamp
Antenna
Discharge Unit
Electric (NEe SECTION 810-20)
Service
-+...
Grounding Conductors
Equipment
I
~
(NEe SECTION 810-21)
t:~:Z=S;:::::
Ground Clamps
~~Power
Service Grounding
Electrode System
(NEe ART 250. PART H)
Cleaning -
Unplug this video product from the wall outlet before cleaning. 00 not use liquid cleaners or aerosol cleaners. Use a damp
cloth for cleaning.
Object and Liquid Entry -
Never push objects of any kind into this video product through openings as they may touch dangerous voltage points or short-
out parts that could result in a fire or electric shock. Never spill liquid of any kind on the video product.
Lightning -
For added protection for this video product receiver during a lightning storm, or when it is left unattended and unused for long
periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the
video product due to lightning and power-line surges.
Service
Servicing -
00 not attempt to service this video product yourself as opening or removing covers may expose you to dangerous voltage or
other hazards. Refer all servicing to qualified service personnel.
Damage Requiring Service -
Unplug this video product from the wall outlet and refer servicing to qualified service personnel under the following conditions:
When the power-supply cord or plug is damaged.
If liquid has been spilled, or objects have fallen into the video product.
If the video product has been exposed to rain or water.
If the video product has been dropped or the cabinet has been damaged.
If the video product does not operate normally be following the operating instructions. Adjust only those controls that are
covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require
extensive work by a qualified technician to restore the video product to its normal operation.
When the video product exhibits a distinct change in performance - this indicates a need for service.
Replacement Parts -
When replacement parts are required, be sure the service technician has used replacement parts specified by the
manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock
or other hazards.
Safety Check -
Upon completion of any service or repairs to this video product. ask the service technician to perform safety checks to
determine that the video product is in proper operating condition.
FUJIFILM Corporation
MIDTOWN WEST, 7-3, AKASAKA 9-CHOME. MINATO-KU. TOKYO
107-0052, JAPAN
Printed in Indonesia BL00372-1 03(1) FPT-608112 1AG6P1 P2835-A