CAUTION!
Avoid Injury
or damage to the unit or other property
•
Provide
occasional
ventilation
during
use.
Do not direct
affflow
at fireplaces
or other
heat
related
sources
as this
could
cause
flare
ups
or make
units
run
excessively.
•
Do not
climb
on or place
objects
on outdoor
part of the
unit.
,
Do not
hang
objects
off the
unit.
•
Do not
place
containers
with
liquids
on the
unit.
•
Turn off the
air conditioner
at the
power
source
when
it will
not be used
for
an extended
period
of time.
•
Periodically
check
the
condition
of the
unit's
installation
accessories
for
any damage.
•
Do not
apply
heavy
pressure
to the
radiator
fins of the unit.
•
Operate
the
unit
with
air filter
in place.
•
Do not
block
or cover
the
intake
grille,
discharge
area and
outlet
ports.
Ensure
that
any electrical/electronic
equipment
is one yard
away
from
the unit.
,
Do not
use or store
flammable
gases
near
the unit.
i
READ THIS SECTION BEFOREATTEHPTING TO OPERATEAIR CONDITIONER.
Unit must be upright
for one hour prior to operating.
Operation of Current Device
Plug
in &
The power
supply
cord
contains
a current
device
that
senses
damage
to the power
cord. To test
press RESET
Remark:
The appearance
of actua_ plug
may be
slightly
different
from the
_ine drawing
shown
in
the figure.
The _ine drawing
is for reference
only.
your
power
supply
cord do the following:
1. P}ug in the Air Conditioner.
2, The power
supply
cord
will have TWO
buttons
on the plug
head.
Press the TEST button.
You will
notice
a click
as the RESET button
pops
out.
3.
Press the RESET button.
Again
you will notice
a click
as the button
engages.
4,
The power
supply
cord
is now supplying
elec_tricity to the unit.
(On some
products
this is also indi-
cated
by a light on the ptug
head).
,
Do not use this device
to turn the
unit on or off.
'
Always
make
sure the RESET button
is pushed
in for con-ect
operation.
The power
supply
cord must
be replaced
if it fails to reset when
either the
TEST button
is pushed,
or it cannot
be reset. A new one
can be obtained
from the
product
manufacturer.
If power
supply
cord is damaged,
it CANNOT
be repaired.
It MUST
be replaced
by one
obtained
from the
product
manufacturer.
@2009
Electrolux
Home
Products,
Inc.
All
rights
reserved.