Air Shutter-Broil Burner; Make Sure Range Is Level - Kenmore 79032363410 Installation Instructions Manual

30" gas range
Table of Contents

Advertisement

Available languages

Available languages

Air Shutter=Broil
Burner
The approximate flame length from the burner is 1 inch
(distinct inner cone of blue flame).
To determine if the broil burner flame is proper, set the
oven to broil.
If flame is yellow in color, increase air shutter opening
size (see "2" in Figure 8 ). If the entire flame is blue,
reduce the air shutter opening size.
To adjust, loosen lock screw (see "3" in Figure 8),
reposition air shutter, and tighten lock screw.
Oven
Burner
Tube
Care, Cleaning
and Maintenance
Refer to the Use & Care Guide for cleaning
instructions.
If moving the range is necessary for cleaning or
maintenance,
shut off gas supply. Disconnect the
gas and electrical supply. If gas or electrical supply is
inaccessible,
lift the unit slightly at the front and pull out
away from the wall.
Pull only as far as necessary to disconnect the gas and
electrical supply. Finish moving the unit for servicing
and cleaning. Reinstall in reverse order making sure to
level the range and check gas connections for leaks.
Lock
Screw
P Orifice Hood
Figure 8
Make sure
range
is level
Level the range by placing a level horizontally on an oven
rack. Check diagonally from front to back, then level the
range by adjusting the leveling legs.
After
installation
is completed,
make sure
all controls
are left in the OFF position.
Before You Call for Service
Read the Before You Call for Service Checklist and
operating instructions
in your Use and Care Guide.
It may save you time and expense. The list includes
common occurrences
that are not the result of
defective workmanship
or materials in this appliance.
Refer to your Use and Care Guide for service phone
numbers.
Serial Plate Information
The serial plate is located as shown. See the serial
plate for the following information:
A. Model, lot and serial number of range.
B. Kilowatt rating (power requirements).
C. Voltage ratings.
LP/Propane
Gas Conversion
This appliance can be used with Natural gas or LP/
Propane gas. It is shipped from the factory for use with
natural gas.
If you wish to convert your range for use with LP/
Propane gas, use the supplied fixed orifices located
in a bag containing the literature marked "FOR
LP/PROPANE
GAS CONVERSION."
Follow the
instructions
packaged with the orifices for surface,
oven and broil burners conversion.
The conversion must be performed by a qualified
service technician in accordance with the
manufacturer's
instructions and all local codes and
requirements.
Failure to follow these instructions
could result in serious injury or property damage.
The qualified agency performing this work assumes
responsibility for the conversion.
Failure to make the appropriate
conversion can result in serious personal injury and
property damage.
10

Advertisement

Chapters

Table of Contents
loading

Table of Contents