Advertisement
Select your measurement to target using drop down
Enter target level
Select target date
Click 'next' to continue
Changing your targets:
If you have achieved your target or wish to set new
targets, simply return to user set-up clicking on 'user
setup' on home page and follow the set up details as
before and chose a new or different target on the
'personal target' page.
To remove a user:
Enter 'user setup' from home page and click 'remove
user'
A pop up box will then ask you if you are sure you
want to remove user.
To remove click 'ok'
Important Note: if you are removing user all data for
this user will be deleted
Enter a password:
If you want to secure your user with password, enter
and confirm password
If you do not want a password then leave blank
Click 'accept' to continue
This will bring you to the home page:
To change user select 'switch user'
This will open the select user box – you can either
choose the correct user for you or set up a new user.
If setting up a new user repeat the original user set
up procedure.
Home page:
To add scales data:
1. Open MiBody360 software
2. Insert USB stick
3. Pop-up shows 'New weigh scales data has been
added'
4. Click 'ok' – it is now safe to remove USB stick.
Note: the scale device memory will be cleared at
this time
Weight page:
To view new data:
1. Click on 'weigh scale' image or title
2. This takes you directly to 'weight' page – you
measurements are plotted as a line graph. Each
point representing a measurement – drag your
cursor over each point for the time and date of
actual measurement to be shown.
3. If you have set a target weight the orange section
of the graph will gradually track towards you
target so you can easily compare your progress
against your target weight.
4. To scroll along your results use the scroll bar
along the base of the graph
5. To zoom in or out of your results use the scroll
wheel on your mouse
6. To view the measurement data as a table select
'table' tab at top of graph
Body Fat page:
1. Your measurements are plotted as a line graph.
Each point representing a measurement – drag
your cursor over each point for the time and date
of actual measurement to be shown.
2. The graph is also split in to zones of 'Low' –
'Optimal' – 'Moderate' – 'High' to give an instant
indication of your health.
3. To view the measurement data as a table select
'table' tab at top of graph
4. 'body fat' definition is shown by dragging cursor
over the 'body fat' tab
5. To view the measurement data as a table select
'table' tab at top of graph
IMPORTANT NOTE:
IF YOU ARE CONCERNED ABOUT YOUR READINGS OR ANY ASPECT OF YOUR HEALTH, HoMEDICS
STRONGLY RECOMMENDS YOU REFER TO YOUR DOCTOR FOR FURTHER ADVISE.
7. To View other parameters select the suitable
'tab' on the lefthand side:
• 'body fat'
• 'body water'
• 'muscle mass'
• 'BMI'
• 'BMR'
Advertisement
