Frigidaire FFLG2022MW3 Installation Manual page 19

Connecting drain and electrical
Form a "U" shape on the end of the drain hose
with the hose pointed toward the drain. Place the
formed end in a laundry tub or a standpipe and
secure the drain hose with the cable tie (provided
in the enclosure package) to the standpipe, inlet
hose, laundry tub, etc. so the hose does not pull
out from the force of the water.
The standpipe inside diameter must be i-i/4" (3.2 cm)
minimum. There must be an air gap around the drain
hose in the standpipe. A snug hose fit can cause a
siph°ning acti0n: ........................................................................................................................
Check to ensure the power is off at a circuit breaker/
fuse box before plugging the power cord into an outlet,
2 Plug the power cord into a grounded outlet,
Power cord with
3-prong grounded plug
3 Turn on the power at the circuit breaker/fuse box.
4 Read the Use & Care Guide provided with the
laundry center. It contains valuable and helpful
information that will save you time and money,
5 Run the washer through a complete cycle, checking
for water leaks and proper operation,
6 If you have any questions during initial operation,
please review the "Avoid Service Checklist" in your
Use & Care Guide before calling for service,
7 Place these instructions in a location near the
appliance for future reference.
CABL
I
I
A wiring diagram and technical data sheet are located
behind the dryer access panel.