Error Messages - Sharp MD-MT80W(S) Service Manual

MD-MT80W/90W/90/90C

Error Messages

ERROR MESSAGES
BATT EMPTY
BLANK MD
Can't COPY
Can't EDIT
Can't READ (*)
Can't REC
Can't STAMP
Can't WRITE
DEFECT
DISC FULL
Er-MD (**)
HOLD
LOCKED
NO DISC
Number or symbol appears in (*) position. (Refer to P.29)
NO SIGNAL
NOT PLAY
PLAY MD
POWER ?
PROTECTED
SORRY
TEMP OVER
TOC FORM (**)
TOC FULL
Tr. Protect
? DISC
Number or symbol appears in (*) position. (Refer to P.29)
MEANING
The battery is run down.
Nothing is recorded.
You tried to record from a copy prohibited
MiniDisc.
A track cannot be edited.
The disc data cannot be read because the
disc or unit is damaged.
Recording cannot be performed correctly
due to vibration or shock.
Stamp function does not work.
Cannot save the TOC information correctly
to a MiniDisc. (A large portion of the disc has
been damaged.)
The disc is scratched.
The disc is out of recording space.
The microprocessor has reported a system
fault and the unit is out of order.
The unit is in the hold mode.
You removed a MiniDisc while recording or
editing.
A disc has not been loaded.
Poor connection of the digital cable.
No output signal comes out from the
connected unit to playback.
The input signal has improper sampling
frequency.
You tried to play back a track that can-
not be played with this equipment.
You recorded on a playback-only disc.
Improper power is being supplied.
The write protection tab of a MiniDisc is
set to the protected position.
You tried to record on a playback-only disc.
Since a track number is currently being
located or updated, the unit cannot ac-
cept your command.
The temperature is too high.
There is an error in the recording signal.
There is no space left for recording
character information (track names,
disc names, etc.).
The track has been protected from be-
ing erased.
A disc which contains data other than
music was played.
There is an error in the signal recorded
on the disc.
REMEDY
Charge the rechargeable battery or replace the al-
kaline battery (or use the AC adaptor for power).
Replace the disc with a recorded disc.
Record using the analog cable.
Change the stop position of the track and then edit it.
Reload the disc.
Replace it with another recorded disc.
Re-record or replace it with another recordable
disc.
Check the number of tracks.
Replace the disc with another recordable disc.
If the sound you hear is not right, record again.
Replace the disc with another recordable disc.
Replace it with another recordable disc.
To have it repaired, go to the distributor where you
purchased the unit.
Cancel the hold mode.
Turn off the power and remove the MiniDisc.
Load a disc.
Connect the digital cable securely.
If the portable CD player has a function to prevent sound
skips, deactivate it.
Playback with the connected unit.
Play back another track.
Replace it with a recordable disc.
Use one of the specified power sources.
Move the write protection tab back to its original posi-
tion.
Replace it with a recordable MiniDisc.
Wait for a while and try the operation again.
Turn off the power, and wait for a while.
Erase all of the tracks, and then record again.
Replace it with another recordable disc.
Edit the track with the device on which it was recorded.
A disc which contains non-music data cannot be played.
Replace it with another recorded disc.
– 10 –