Whirlpool WFW88HEAW1 Use & Care Manual page 12

USING YOUR WASHER
1 0. Select any additional options*
Steam Clean _EcoBoost Fan Dry Extra Rinse Cycle S_gnal Control Lock
Hold 3 set or_d Hold 3 seconds Hold 3 s_or_r_s
for D, #_, Ught for Button _ounds
iii,
ii
-i
ii
Appearance may vary.
To add an option to the cycle, touch its name - Steam Clean,
EcoBoost
TM
option, Fan Dry/TumbleFresh
TM,
Extra Rinse, Cycle
Signal, or Control Lock. To remove an option from the selected
cycle, touch the option again.
1 1. Setting a delayed wash
If you do not want to begin a cycle immediately, you may
choose the DELAY WASH option. This will delay the start
of the wash cycle by up to 12 hours.
To set a delayed wash:
1. Touch DELAY WASH + and - buttons to set the desired
delay time.
2. Touch and hold START to set the delay. The delay
countdown has started when the START light stops blinking.
1 2. Touch and hold START to begin
wash cycle
_iiiiiiii:_iii;iii_
Hold to Start
Touch and hold START to start the wash cycle. To pause a cycle
in progress, touch START once, then touch and hold again to
continue the cycle. To cancel a cycle, touch POWER.
Once you touch and hold START, you will hear the door lock, un-
lock, and lock again. The washer door will remain locked during
the wash cycle.
Unlocking the door to add garments:
If you need to open the door to add 1 or 2
missed garments, you may do so while the
"Add Garment" light is lit.
Touch START once; the door will unlock
once the washer movement has stopped.
This may take several minutes. Then close
door and touch and hold START again to
restart the cycle.
_SD Add Garment i
12
Hold to Sta_'t
f13,
Remove garments promptly
after cycle is finished
for small items between the tub and the washer drum.
If you will be unable to remove the load
promptly, use the Fan Dry or TumbleFresh _=
option (depending on model). If selected,
the Fan Dry option will activate the fan and
tumble the load periodically for up to 12 hours.
The TumbleFresh '= option will tumble the
load periodically for up to 6 hours. To turn off
the Fan Dry or TumbleFresh '=option, touch
POWER. To set the washer so that the Fan Dry/TumbleFresh '=
option does not come on for future cycles, touch Fan Dry or
TumbleFresh.
immllllf- _
Fan Dry
OR
::i
TumbleFresh
NOTE:
[] The door will remain locked while the Fan DryFFumbleFresh '=
option is active. To cancel the option and unlock the door,
touch POWER.
[] A small amount of water may remain in the dispensers after
the wash cycle is complete. This is normal.
[] This washer has a tight seal to avoid water leaks. To avoid
odors, leave the door open to allow the washer to dry between
uses.
*Not all options and settings are available with all cycles.
See "Cycle Guide" for available options and settings.