Advertisement
Available languages
Available languages
Check that leveling legs are firmly against the floor. Close and
latch the door, and place level against the front panel. Check that
dishwasher is centered from front to back in the opening. If
needed, adjust leveling leg until dishwasher is plumb. Repeat for
other side of dishwasher.
Helpful Tip: Push up on front of dishwasher to raise dishwasher
off the ground to adjust front legs. With some installations, it may
be easier to adjust the front leg using the ¾6" hex head socket or
adjustable wrench.
Place level against top front opening of tub. Check that
dishwasher is level from side-to-side.
If dishwasher
is not level,
adjust front legs up or down until dishwasher is level. Close the
dishwasher door.
11)1111881,1,8'_''"
.... oI}II
II .........
_I..;I
Copper tubing only: Slide nut, then ferrule, about 1" (2.5 cm) onto
copper tubing.
NOTE: To avoid vibration during operation, route the water supply
line so that it does not touch the dishwasher base, frame or motor.
Add 90 ° elbow
fitting
to the
water supply
line
Connect the 3/8"compression
fitting to the water supply line prior
to installing the unit into the cabinet opening. Attach so that the
3/4"connection is facing upward as shown above.
Copper tubing only: Put the tubing into the 90 ° elbow fitting as far
as it will go (the copper tubing bends and kinks easily). Slide the
nut and ferrule forward and start the nut onto the elbow threads.
Flexible braided connection: Secure nut to elbow using %" open
ended wrench or adjustable wrench.
NOTE: Do not use Teflon ®ttape with compression fittings.
1-®TEFLON is a registered trademark
of E.I. Du Pont De Nemours and Company.
18
Advertisement
