Pile Height Selection And Settings; Check Bag Indicator - Kenmore 116.31140 Use & Care Manual

PiLE HEIGHT SELECTION AND SETTINGS
Select a pile height setting by turning the
height adjust selector located on the
nozzle,
L/- Height Adjust
SUGGESTED PILE HEIGHT SETTINGS
There are four (4) pile height settings on
the vacuum cleaner. For best deep down
cleaning, use the LO setting. However, you
may need to raise the height to make
some jobs easier, such as scatter rugs and
some deep pile carpets, and to prevent
the vacuum cleaner from shutting off.
Attention: Refer to your carpet
manufacturers cleaning
recommendations. Some more delicate
carpets may require that they be
vacuumed with the agitator turned off to
prevent carpet damage.
Suggested settings are:
HI - Shag, deep pile, or scatter rugs.
MED HI - Medium to deep pile.
MED LO - Low to medium pile.
LO - Most carpets, bare floors combined
with FLOOR power switch setting,
delicate carpets that require agitator to
be turned off.
I AUTION
_Do not allow vacuum cleaner to remain
_in one spot for any length of time when
_the agitator is turning. Damage to carpet
may occur.
CHECK BAG INDICATOR
When the vacuum cleaner is runningwith
normal air flow, the light on the CHECK
BAG indicator isoff.
NOTE: It is normal for the CHECK BAG
indicator to come on when using certain
attachments, due to reduced airflow
through attachment. No maintenance is
required.
The light comes on when:
* Bag is full. See CHANGING DUST BAG
(Page 15)
" The airflow isblocked. Check motor
safety filter and other possibledog
locations shown in REMOVING CLOGS.
(Pages 19-20)
* When using some attachments.
"AG
- 10 -