Attaching The Seat; Tire Pressure - Craftsman T1000 247.203701 Operator's Manual

F
\
Figure3
3.
Place the steeringwheel capoverthe centerof the steeringwheeland
pushdownwarduntil it"clicks"into place.
Attaching The Seat
If the seatforyourtractorwasnot attached at the factory,referto the following
steps.
NOTE: Forshippingreasons, seatsareeitherfastened to the tractorseat'spivot
bracket w ith a plastic tie, or mountedbackward to the pivotbracket. I neithercase,
freethe seatfrom its shipping positionandremove the adjustment k nobfrom the
bottomofseatbeforeproceeding with the instructions below.
1. Asalreadyinstructed, r emove the seatadjustmentknobinstalledbythe
factoryin the bottomofthe seat.See"a"in Figure 4.
®
Slidethe seatrearwardin the seatpivotbracket(c),liningup the center
rearslotinthe pivot bracket w ith the remainingholeinthe seat's base.See
Figure 5.
Note: Becertainthe two seattabsengauge the pivot bracket a sshownin
the bottominsetof Figure 5.
Figure 5
4. Selectdesired positionforthe seat,andsecure with the adjustment k nob
removed earlier(din Figure 5).
5. Toadjustthe positionof the seat,remove the adjustment k nobon the
bottomof the seat.Slidethe seatforwardor backward asdesired. R einstall
the adjustmentknob.SeeFigure 5.
Tire Pressure
Maximum tire pressure u nder anycircumstances is30 psi.Equal t ire pressure
shouldbe maintained at all times. Neverexceedthe maximum inflation
)ressure shown on the sidewallof the tire.
The recommended operating t irepressure is:
Approximately 10psi f ortherear tires
Approximately 14psi f orthefronttires
IMPORTANT: Referto the tire sidewallfor exacttire manufacturer's
recommended or maximumpsi. Donot overinflate.Uneventire
pressurecouldcausethe cuttingdeckto mowunevenly.
2.
Figure4
Alignthe seatoverthe seatpivot bracket a sshownin Figure 4andfit the
seatontothe pivotbracketinsertingthe two tabsonthe seatbottominto
the slotsonthe pivotbracket.
10