Attaching The Seat; Adjusting The Seat; Tire Pressure - Craftsman T1600 247.203744 Operator's Manual

2.
Place the washer(with thecuppedsidedown)overthe steeringwheeland
secure with the hexbolt. SeeFigure 3.
Figure3
3.
Place the steedngwheelcapoverthe centerof the steeringwheelandpush
downwarduntil it "clicks"into place.
Attaching The Seat
NOTE: Forshippingreasons, the seatiseitherfastened to the tractorseat's pivot
bracket w ith a plastic tie, or mountedbackward to the pivotbracket. I neithercase,
freethe seatfrom its shipping positionbeingcareful n ot to bendor kinkthe wiring
harness a ndfollowthe instructions belowto attachit.
1. Remove t he two hexscrews andnutsfromthe seatpivotbracket.
2. Alignthe front holesofthe seatmountingbracket w ith the holesinthe seat
pivotbracketonyourtractorandsecure with previously removedhexscrews
andnuts. SeeAinFigure 4.
3. Plugthe wiring harness intothe seatsafetyswitchinthe bottomof the seat,
asshownin Bof Figure 4.
NOTE: The tractorwill not operate with the wiring harness disconnected.
Adjusting the Seat
Toadjustthe positionof the seat,pull upandholdthe seatadjustmentlever. S lide
the seatforwardor rearwardto the desired position;thenrelease the adjustment
lever. M akesureseatislocked into positioninaseat-stop beforeoperating the
tractor.SeeFigure 5.
Beforeoperatingthe tractor, makesurethe seat isengagedin aseat-stop.
Engage the parkingbrake.Stand behindthe machineand pull backon seat
until it clicksintoplace.
Figure 5
Tire Pressure
Maximum tire pressureunder anycircumstances is30 psi.Equal t ire pressure
shouldbe maintained at all times. Neverexceedthe maximum inflation
)ressure shown on the sidewallof the tire.
The recommended operating t irepressure is:
Approximately 10psi f ortherear tires
Approximately 14psi f orthefronttires
IMPORTANT= Referto the tire sidewallfor exacttire manufacturer's
recommended or maximumpsi. Donot overinflate.Uneventire
pressurecouldcausethe cuttingdeckto mowunevenly.
Figure4 10