Advertisement
Operating
Instructions
(continued)
REMOTE SENSING FEATURE
(on some models):
,MP_J.,,
=_I
DO THIS:
PRESS REMOTE
SENSING
_Z!_::_|START BUTTON
clean
air
LIGHT pulsing ( On & Off intermittently
),
econ
sensing
#n only
m
timer
MODE
V
ON-OFF
A
NOTE: Unit display shows the set temperature
Note: This feature can be activated from the remote control ONLY, the unit must be in a cooling mode,
NOTE: Remote
display
is actual temperature
at remote
control
only
To activate the remote sensing feature,
point the remote control towards the unit and press the remote sensing Start button, Next, use
the"
A V "buttons
to set the desired temperature
at the remote, {Note that the set temperature
will only be displayed on the unit
itself ), The LIGHT on the unit control will pulse to indicate it received the signal, The LIGHT on the remote control will pulse each time it
sends a signal, It will periodically
send this signal until the feature
is deactivated
by pressing the remote sensing Stop button, If the unit
does not receive the remote
sensing signal during any 3 minute interval,
the unit will beep to indicate the remote sensing mode has
ended, The display on the remote control
indicates the temperature
at the remote ONLY,
NOTE: The Remote Sensing function
is terminated
either by using the Remote Sensing Stop button or the main ON/OFF button on the
unit,
FAULT
CODES:
ON-OFF
auto
l
_
m_ "
filter
to
reset
A
FAN SPEED steep
If the display
reads "AS",
a sensor has failed.
Contact your
Authorized
Frigidaire
Service Center.
TO CHANGE TEMPERATURE DISPLAY:
L
temp/timer
.
"}
_ Z
° J
reset
ON-OFF
A
FAN SPEED steep
I
"
/DO THIS:
PRESS AND HOLD THE
UP/DOWN
BUTTONS
TOGETHER
FOR 3 SECONDS
YOU WILL SEE:
temp/timer
?
ON-OFF
auto
l
c
_
mh_"
filter
to
reset
A
FAN SPEED sleep
Note: The control
is capable
of displaying
temperature
in
degrees
Fahrenheit
or degrees
Celsius.
@2009 Electrolux
Home Products,
Inc.
All rights reserved.
Advertisement
