Whirlpool 4GWTW4740 Installation Instructions Manual page 9

POWER CORD INSTALLATION
"a,
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Plug power supply cord into an grounded outlet. Turn power
supply on.
Select plug
Select the plug that fits with the electric receptacle.
18, Secure power cord
Secure the power cord by seating the connection on the cord
lock. Place the cord lock cover and push until it snaps. Make
sure the power cord connection is seated on the cord lock and
that the cord lock clamps correctly.
COMPLETE INSTALLATION
CHECKLIST
[_ Check electrical requirements. Be sure you have correct
electrical supply and recommended grounding method.
[_ Check that all parts are now installed. If there is an extra
part, go back through steps to see what was skipped.
[_ Check that you have all of your tools.
[_ Check that shipping materials were completely
removed from washer.
C3
C3
C3
C3
C3
C3
C3
Check that water faucets are on.
Check for leaks around faucets and inlet hoses.
Remove film from console and any tape remaining on washer.
Check that washer is plugged into a grounded
outlet.
Dispose of/recycle all packaging materials.
Read "Washer Care" in your Use and Care Guide.
To test and clean your washer, measure 1/2 of normal
recommended amount of powdered or liquid detergent
and pour it into washer basket or detergent dispenser
(on some models). Close lid. Select any cycle. Start washer
and allow to complete full cycle.
Assemble the plug into the end of the power cord.