LG PG60G Owner's Manual page 4

4
SAFETY INSTRUCTIONS
Do not install the product onto a wall
y
or ceiling that is close to sources of
oil or oil mist.
- The product may be damaged and
fall, resulting in serious injury.
Do not place the projector where it
y
might be exposed to excessive dust.
- This may cause a fire.
Do not use the projector in a damp
y
place such as a bathroom where it is
likely to get wet.
- This may cause a fire or an electric
shock.
Do not allow a tablecloth or curtain to
y
block the vents.
- This may cause the internal
temperature of the projector to rise
and cause a fire.
The distance between the projector
y
and the wall should be more than 30
cm for ventilation purposes.
- Otherwise, this may cause the
internal temperature of the projector
to rise and cause a fire.
CAUTION
When installing the projector on a
y
table, be careful not to place it near
the edge.
- The projector may fall causing injury
to persons or damage to the projec-
tor. Make sure that you use a stand
suitable for the size of projector.
Turn off the projector, disconnect the
y
power supply and remove all connec
tions before moving the projector.
- A damaged cord may cause a fire
or an electric shock.
Do not install the projector on an
y
unstable or vibrating surface such as
a vibrating shelf or tilted surface.
- It may fall and cause injury.
Be careful not to tip the projector over
y
when connecting external devices to
the projector.
- This may cause injury to persons or
damage to the projector.
Power
WARNING
The ground wire should be connected.
y
- Inappropriate earth grounding may
cause damage to the projector or
an electric shock when there is an
electrical surge.
If the projector must be installed at
a place where earth grounding is not
possible, purchase a circuit breaker
and connect the projector to its wall
outlet.
Do not ground the projector to the
gas pipe, water pipe, lightning rod or
telephone line, etc.
The power plug should be fully
y
inserted into the wall outlet.
- Unstable connection may cause a fire.
Do not place heavy objects on the
y
power cord or place the cord
underneath the projector.
- This may cause a fire or an electric
shock.
Never touch the power plug with a
y
wet hand.
- This may cause an electric shock.
Do not connect too many devices to
y
the same power extension.
- Overheating may cause a fire.
Remove dust or contaminants around
y
power plug pins or wall outlets.
- This may cause a fire.
To turn off the main power, remove the
y
power plug, which should be positioned
so it is easy to access for operation.