Connecting A Strobe Device - Omron F160 Vision Sensor Setup Manual

Connecting a Strobe Device

Cam- Cam- Shutter
era
era
speed
F300- Stan- SYNC
S3DR dard
NON
RESET
F300- Stan- SYNC
S4R dard
NON
RESET
Note
5-6

Connecting a Strobe Device

SeeAlso
64
Syn- Strobe
chroni-
disable
zation
Start End
Exter- -10 -8
nal
-2 0
3 5
5 7
Exter- -16 -14
nal
-11 -9
-8 -6
-6 -4
-5 -3
-3 -1
-3 -1
-2 0
-2 0
-2 0
1. The shutter speed is set in the Camera itself, so the shutter speed setting
displayed in the F160 Menu is ignored.
2. Set the shutter trigger pulse width to match the strobe's specifications only
when a strobe is being used.
3. These settings (indicated by ---) are ignored.
Use the I/O connector's strobe trigger outputs to control the strobe flash tim-
ing. There are two strobe trigger outputs, STGOUT0 and STGOUT1, i.e., one
for each of camera 0 and camera 1.
Refer to page 31 for details.
Check the strobe device's specifications and set the appropriate "Shutter trig-
ger polarity" and "Shutter trigger width" in the Camera settings (Detail) Menu.
The Camera settings (Detail) window is displayed at startup and can be dis-
played at other times by selecting Camera settings from the System Menu.
Shutter Clamp pulse
1
speed
Tim- Width Width Polar-
ing
1/1,000 90 25
1/2,000
1/4,000
1/10,000
1/1,000 90 25
1/1,500
1/2,000
1/3,000
1/4,000
1/6,000
1/8,000
1/10,000
1/30,000
1/50,000
Section 5-6
Shutter Exter- Image
read Y
trigger pulse nal
timing
VD
3
Sync
ity
7 Nega- OFF ---
tive
7 Nega- OFF ---
tive
3