Power Supply And Ground; Crimp Terminals And Cables; Ground (Earth) Wiring - Omron F160 Vision Sensor Setup Manual

Power Supply and Ground

SeeAlso
2-6

Power Supply and Ground

2-6-1

Crimp Terminals and Cables

2-6-2

Ground (Earth) Wiring

18
• The lens has a fixed focal point. The actual field of vision and focal point
vary from lens to lens, so adjust the distance to the measurement object
after replacing the lens or camera.
• The camera mounting distance listed in the following tables is an approxi-
mate value. Mount the Camera so that the distance to the measurement
object can be adjusted easily.
If the object size and field of vision are incompatible, use a standard CCTV
lens and light source.
page 22
Wire the power supply and the ground to their respective terminals. Tighten
the screws to a torque of between 0.49 N•m.
After wiring, confirm that the wiring is correct.
The terminal block uses M3 terminal screws. Use appropriate crimp terminals
for M3 screws, as shown below.
Forked
6.2 mm max.
Applicable wire size: Insulated wire of 1.31 to 1.65 mm
Always connect a ground wire to the F160's ground terminal. To avoid ground-
ing problems, do not share the ground wire with any other devices or wire the
ground to the building's steel framing.
Use a grounding point that is as close as possible and keep the ground wire as
short as possible.
F160
Round
6.2 mm max.
Ground to 100 Ω or less.
Section 2-6
2
(AWG16 to AWG15)