Status Message
Setting
Status Message
Network Settings
IMPORTANT
We recommend configuring these settings with your administrator or dealer. Network settings can also be
configured through Web user interface programming (Page 58). Contact your administrator or dealer for
further information.
Network
Setting
IP Address Mode
IPv4
IPv6
Document Version 2014-11
Description
View a list of status messages for the
unit. Press [ ] and [ ] to display the
various messages.
Sub-Setting
—
Specify the IP address mode
to use.
Enable DHCP
Enable or disable DHCP for
IPv4.
IP Address
If DHCP is not enabled, you
must specify the IP address.
Subnet Mask
If DHCP is not enabled, you
must specify the subnet
mask.
Default Gateway
If DHCP is not enabled, you
must specify the default
gateway.
Auto DNS
Enable or disable Auto DNS
for IPv4.
DNS1
If Auto DNS is not enabled,
you can specify the primary
DNS server IP address.
DNS2
If Auto DNS is not enabled,
you can specify the
secondary DNS server IP
address. Leave blank if a
secondary DNS server is not
used.
Enable IPv6
Enable or disable DHCP for
DHCP
IPv6.
Allow Auto
Enable or disable auto
Configuration
configuration for IPv6.
Description
Customizing the Telephone
Value Range
—
Value Range
IPv4 only
IPv6 only
Dual stack
Yes, No
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
Yes, No
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
Yes, No
Yes, No
Operating Instructions
Default
—
Default
Dual
stack
Yes
—
—
—
Yes
—
—
Yes
Yes
49