Table of Contents
Advertisement
notice the adjustment is off, kindly do as
f
0 1
I
ows.)
Loosen the pan head screw for each roller
under the table. Use
a
screwdriver to rotate
the groove on the roller adjuster within
180 degrees on the four roller
axes. Refer
to
the figures for the correct range of
adjustment of each roller adjuster. Rotat-
ing the groove in the ascending direction
causes the bed roller to rise; turning the
groove down causes the bed roller to lower.
NOTE :
The above adjustment procedure should be
Range of groove rotation
on
roller adjuster
to
adjust height o f bed roller (left).
Range of
groove
roation on roller adjuster
t o adjust
of
bed roller (right).
Fig. 1 1
Caution
Unless the
two
groove positions on the one roller face the same direction, the stock may
be twisted to the left or right.
I f the rollers protrude too much, notching may result in the surface planed
on
the
opposite end. The protrusion from the table surface should be
0.1
-
0.3mm (postcard
thickness). Tighten the small screw when the adjustment has been made.
Hide quick links:
Advertisement
Table of Contents
